Term · Advanced
Three-Phase Power
Power delivered on three hot legs offset in timing, used by studios and large generators for big loads.
Three-phase power uses three hot conductors whose alternating currents are offset by a third of a cycle, plus a neutral and ground. It delivers more power through smaller cable than single-phase, so studios, stages and tow plants use it; in North America it's commonly 120/208 volts. Electricians balance the load across the three legs so no single leg is overloaded.
Also called 3-phase, three phase, 3-phase power
Related
- Single-Phase PowerPower delivered on one alternating supply; US homes get split-phase, with two 120 volt legs.
- Feeder CableHeavy power cable that carries large amounts of current from a generator or tie-in to distribution boxes.
- GeneratorAn engine-driven power source that runs lights and gear where house power isn't enough or isn't there.
- Distro (Distribution)The gear that takes one big power feed and splits it into safe, breaker-protected outlets for the lights.
- Load CalculationAdding up your lights' watts and converting to amps to make sure circuits and generators can carry them.